astracrazy wrote:Matt - your 100% right . Mainly i'm doing it because learning to use solidworks was a lot easier just on a rear wing. Ideally i'd create the whole car 1st then test the rear wing, but i'm not sure that my computer could handle that all together. I'll obviously try to add bits to the simulation to see what happens.
Ricme - solidworks, took all sunday (today) to work it all out (finding different tutorial etc) i can write some quick instructions for you? It is quiet simple once you know.
As i said, Matts right, but in terms of just the rear wing (or any other simulation) what should i look for to make improvements? Using the rear wing as an example. New to reading into cfd results
Users browsing this forum: machin and 1 guest