Scuderia Ferrari SF72H Speculation Thread

A place to discuss the characteristics of the cars in Formula One, both current as well as historical. Laptimes, driver worshipping and team chatter does not belong here.
timbo
timbo
118
Joined: Mon Oct 22, 2007 9:14 am

Re: Scuderia Ferrari SF72H Speculation Thread

Post

What would be the point of having such an exhaust arrangement?
You'd get some blowing effect, but where? What is the percentage of time per lap the turbine is running overboost? Also, what good is in having exhaust driven effect which occurs very abruptly? Wastegates can't be electronically controlled, right?

Zynerji
Zynerji
78
Joined: Wed Jan 27, 2016 3:14 pm

Re: Scuderia Ferrari SF72H Speculation Thread

Post

timbo wrote:
Sun Feb 10, 2019 5:37 am
What would be the point of having such an exhaust arrangement?
You'd get some blowing effect, but where? What is the percentage of time per lap the turbine is running overboost? Also, what good is in having exhaust driven effect which occurs very abruptly? Wastegates can't be electronically controlled, right?
It would be interesting to see if the waste gate exhaust gives the ultimate wing effect, or if it is simply a pulse entrainment of the ICE exhaust gases below it.

User avatar
outsid3r
11
Joined: Thu Nov 01, 2012 9:55 pm

Re: Scuderia Ferrari SF72H Speculation Thread

Post

Can the different wastegate layout be turbo related? I noticed that Honeywell is out of the suppliers list and Garrett is in. Maybe they worked out something clever in conjunction with Garrett?

User avatar
godlameroso
406
Joined: Sat Jan 16, 2010 8:27 pm
Location: Miami FL

Re: Scuderia Ferrari SF72H Speculation Thread

Post

timbo wrote:
Sun Feb 10, 2019 5:37 am
What would be the point of having such an exhaust arrangement?
You'd get some blowing effect, but where? What is the percentage of time per lap the turbine is running overboost? Also, what good is in having exhaust driven effect which occurs very abruptly? Wastegates can't be electronically controlled, right?
The wastegates are electronically controlled by hydraulic actuators.
The height of cultivation is really nothing special. It is merely simplicity; the ability to express the utmost with the minimum. Mr.Lee

User avatar
godlameroso
406
Joined: Sat Jan 16, 2010 8:27 pm
Location: Miami FL

Re: Scuderia Ferrari SF72H Speculation Thread

Post

outsid3r wrote:
Sun Feb 10, 2019 10:53 am
Can the different wastegate layout be turbo related? I noticed that Honeywell is out of the suppliers list and Garrett is in. Maybe they worked out something clever in conjunction with Garrett?
Honeywell is the parent company of Garrett.
The height of cultivation is really nothing special. It is merely simplicity; the ability to express the utmost with the minimum. Mr.Lee

enri_the_red
enri_the_red
13
Joined: Tue Jul 03, 2012 1:12 pm
Location: Italy

Re: Scuderia Ferrari SF72H Speculation Thread

Post

According to the italian version of motorsport.com ( https://it.motorsport.com/f1/news/diret ... a/4311502/ ) , last December the FIA issued a technical directive stating that the two wastegate exhausts must blow in the same way

bosyber
bosyber
46
Joined: Tue Sep 15, 2015 9:41 pm

Re: Scuderia Ferrari SF72H Speculation Thread

Post

Thanks everyone for the replies,that makes a lot of sense. I didn't doubt, just wondered if I missed some obvious clues (or was just too dense!)
enri_the_red wrote:
Sun Feb 10, 2019 2:50 pm
According to the italian version of motorsport.com ( https://it.motorsport.com/f1/news/diret ... a/4311502/ ) , last December the FIA issued a technical directive stating that the two wastegate exhausts must blow in the same way
but if the bottom pipe makes an almost 90 degree bend, with the top one much more straightforward, no doubt 'due to packaging /geometry', how would you stop them? Sure I suppose FIA/rivals could argue it is a sort of simple fluidic valve, but would that really fly?

User avatar
PlatinumZealot
446
Joined: Thu Jun 12, 2008 2:45 am

Re: Scuderia Ferrari SF72H Speculation Thread

Post

The dummy pipe underneath could function as a silencer if my knoelwedge on silencers is up to snuff. They don't want you to know when that thing is blowing the wing!

Tzk
Tzk
24
Joined: Sat Jul 28, 2018 11:49 am

Re: Scuderia Ferrari SF72H Speculation Thread

Post

I finally found a good picture of the 2018 exhaust test in hockenheim... blue lines were added by me.

Image

BassVirolla
BassVirolla
2
Joined: Fri Jul 20, 2018 10:55 pm

Re: Scuderia Ferrari SF72H Speculation Thread

Post

Could it be a fluidic switch to engage the main exhaust stream to the wing only with a pulse of wastegate?

BwajSF
BwajSF
5
Joined: Mon Mar 12, 2018 10:33 am

Re: Scuderia Ferrari SF72H Speculation Thread

Post

bosyber wrote:
Sun Feb 10, 2019 6:43 pm
Thanks everyone for the replies,that makes a lot of sense. I didn't doubt, just wondered if I missed some obvious clues (or was just too dense!)
enri_the_red wrote:
Sun Feb 10, 2019 2:50 pm
According to the italian version of motorsport.com ( https://it.motorsport.com/f1/news/diret ... a/4311502/ ) , last December the FIA issued a technical directive stating that the two wastegate exhausts must blow in the same way
but if the bottom pipe makes an almost 90 degree bend, with the top one much more straightforward, no doubt 'due to packaging /geometry', how would you stop them? Sure I suppose FIA/rivals could argue it is a sort of simple fluidic valve, but would that really fly?
Or Simple... This might be looked at as some perfume bottle concept...
The Upper Pipe is where the fast moving gases go through.. since the lower one is at 90 degrees the fast moving exhaust gases in the upper tube might cause the atmospheric air to be pulled inside from the lower tube and mix with the fast moving gases in the upper tube causing the temperature of the wastegate to reduce a bit... and also since the atmospheric air is being pulled into the wastegate pipe...it might add to some sort of performance to the rear of the car..just guessing....

User avatar
GTO99
1
Joined: Tue Feb 16, 2016 2:12 am

Re: Scuderia Ferrari SF72H Speculation Thread

Post

BwajSF wrote:
Mon Feb 11, 2019 7:17 am
bosyber wrote:
Sun Feb 10, 2019 6:43 pm
Thanks everyone for the replies,that makes a lot of sense. I didn't doubt, just wondered if I missed some obvious clues (or was just too dense!)
enri_the_red wrote:
Sun Feb 10, 2019 2:50 pm
According to the italian version of motorsport.com ( https://it.motorsport.com/f1/news/diret ... a/4311502/ ) , last December the FIA issued a technical directive stating that the two wastegate exhausts must blow in the same way
but if the bottom pipe makes an almost 90 degree bend, with the top one much more straightforward, no doubt 'due to packaging /geometry', how would you stop them? Sure I suppose FIA/rivals could argue it is a sort of simple fluidic valve, but would that really fly?
Or Simple... This might be looked at as some perfume bottle concept...
The Upper Pipe is where the fast moving gases go through.. since the lower one is at 90 degrees the fast moving exhaust gases in the upper tube might cause the atmospheric air to be pulled inside from the lower tube and mix with the fast moving gases in the upper tube causing the temperature of the wastegate to reduce a bit... and also since the atmospheric air is being pulled into the wastegate pipe...it might add to some sort of performance to the rear of the car..just guessing....
Good theory, I'll buy that.

User avatar
henry
268
Joined: Mon Feb 23, 2004 7:49 pm
Location: England

Re: Scuderia Ferrari SF72H Speculation Thread

Post

BwajSF wrote:
Mon Feb 11, 2019 7:17 am
bosyber wrote:
Sun Feb 10, 2019 6:43 pm
Thanks everyone for the replies,that makes a lot of sense. I didn't doubt, just wondered if I missed some obvious clues (or was just too dense!)
enri_the_red wrote:
Sun Feb 10, 2019 2:50 pm
According to the italian version of motorsport.com ( https://it.motorsport.com/f1/news/diret ... a/4311502/ ) , last December the FIA issued a technical directive stating that the two wastegate exhausts must blow in the same way
but if the bottom pipe makes an almost 90 degree bend, with the top one much more straightforward, no doubt 'due to packaging /geometry', how would you stop them? Sure I suppose FIA/rivals could argue it is a sort of simple fluidic valve, but would that really fly?
Or Simple... This might be looked at as some perfume bottle concept...
The Upper Pipe is where the fast moving gases go through.. since the lower one is at 90 degrees the fast moving exhaust gases in the upper tube might cause the atmospheric air to be pulled inside from the lower tube and mix with the fast moving gases in the upper tube causing the temperature of the wastegate to reduce a bit... and also since the atmospheric air is being pulled into the wastegate pipe...it might add to some sort of performance to the rear of the car..just guessing....
An interesting theory. It might be prohibited by this regulation:
5.8.2 Engine exhaust systems must have only a single turbine tailpipe exit and either one or two wastegate tailpipe exits which must all be rearward facing and through which all exhaust gases must pass. All and only the turbine exit exhaust gases must pass through the turbine tailpipe and all and only the wastegate exhaust gases must pass through the wastegate tailpipe(s). None of the tailpipes may be contained within any of the other tailpipes.
Fortune favours the prepared; she has no favourites and takes no sides.
Truth is confirmed by inspection and delay; falsehood by haste and uncertainty : Tacitus

BwajSF
BwajSF
5
Joined: Mon Mar 12, 2018 10:33 am

Re: Scuderia Ferrari SF72H Speculation Thread

Post

henry wrote:
Mon Feb 11, 2019 10:25 am
BwajSF wrote:
Mon Feb 11, 2019 7:17 am
bosyber wrote:
Sun Feb 10, 2019 6:43 pm
Thanks everyone for the replies,that makes a lot of sense. I didn't doubt, just wondered if I missed some obvious clues (or was just too dense!) but if the bottom pipe makes an almost 90 degree bend, with the top one much more straightforward, no doubt 'due to packaging /geometry', how would you stop them? Sure I suppose FIA/rivals could argue it is a sort of simple fluidic valve, but would that really fly?
Or Simple... This might be looked at as some perfume bottle concept...
The Upper Pipe is where the fast moving gases go through.. since the lower one is at 90 degrees the fast moving exhaust gases in the upper tube might cause the atmospheric air to be pulled inside from the lower tube and mix with the fast moving gases in the upper tube causing the temperature of the wastegate to reduce a bit... and also since the atmospheric air is being pulled into the wastegate pipe...it might add to some sort of performance to the rear of the car..just guessing....
An interesting theory. It might be prohibited by this regulation:
5.8.2 Engine exhaust systems must have only a single turbine tailpipe exit and either one or two wastegate tailpipe exits which must all be rearward facing and through which all exhaust gases must pass. All and only the turbine exit exhaust gases must pass through the turbine tailpipe and all and only the wastegate exhaust gases must pass through the wastegate tailpipe(s). None of the tailpipes may be contained within any of the other tailpipes.
Yup.. But that a rule focused more to direct only the wastegate gases through the tailpipe.. and not the engine exhaust... Besides by definition the exhaust design doesnt pass anything more than the what is mentioned in the rule... its just that the atmospheric air gets pulled in as a result of design so i guess its kinda grey area..
I believe such exhaust design has huge advantage in long straights... where the engine revs to its peaks exhaust gases keeps rushing out with monstrous velocity both from turbine and engine.. and hence this design might aid on straights... and since in corners its more of treading the throttle it wouldnt be much of an effect...
but again.. we all are just swinging the dark.. so any swing is a good swing...

User avatar
Blackout
760
Joined: Tue Feb 09, 2010 3:12 am

Re: Scuderia Ferrari SF72H Speculation Thread

Post