sketchup help

[astracrazy]

Hi guys,

has anyone got any tips for joining two opposite curves, or plugins to aid. For example i'm trying to do the front wing where the flap meets the endplate, but a common feature is the endplate curves out and so does the flap connected to it.

anytips on this sort of thing? I understand the intersect tool would work, but i haven't got it - i've got the free version

perhaps we could use this thread too to trade tips, plugins etc

[RicME85]

Just get pro, it makes sense.
Go to kat.ph and search for sketchup. There are also a couple of books in pdf format that are worth grabbing to learn new tricks

[astracrazy]

ye i might have to, was just trying to see what plugins are about and if there is anything to do the job or other ways of doing it