You guys are making your life too difficult. Just design the diffuser and then separately the fences. The parts do not have to be one closed compound. It is OK for the fences to intersect the diffuser floor. Just make sure that no parts are "in the air", held by nothing.
rjsa wrote: ↑
Wed Jun 21, 2017 11:12 am
This is something that bothers me: I have never seen a flow report for intake or exhaust. I've ran 100s of interactions but never took part in an actual race. Is it supposed to show on my reports? Where? How?
There should be numbers and plots in the report.
I have finally successfully packaged the new software. It will be available for download very soon now. If you continue to not get any report, please use the new Q&A section that I will make available latest tomorrow to report this issue and I will fix it.