F1technical.net

Hi all My Friend and I need your assitance, we have come up with a design for a single seater. We need someone to help us make full 3d models of it, if there is anyone who can do that please can you help.

We designed the car because eventually we hope to get it made.
Please tell us what you think of the design.

You may need a little bit of other information to help the designer, a full car like that would take a long time!

yeah I get you thanks

the width of the car wont exceed 2m, so around 1850 mm the wheel base will be 1700 mm. wheels, width 11.5 inches (292 mm), diameter 13 inches

PM me for rates

thanks will do

You don't really need someone who makes a 3D model of your picture,
you need some people who really design the car.
This means placing all the components, suspension layout, stiffness calculation....


Making a 3D CAD model is only the monkey job, almost everybody can do that or learn that.

For a good basic design I might help you a bit, when you are really serious about building it as a real car.

My rate is flynfrog's * 0.9

Jersey Tom wrote:My rate is flynfrog's * 0.9

Can someone model a sports proto for me?

[-o< [-o< [-o<

Belatti wrote: Can someone model a sports proto for me?

BTW, Im serious with this. I guess this model is easier than a formula car to do. The front floor is flat and the rear has a 80cm diffuser starting from the rear wheel axle.
The car has 2480mm wheel base and 1650mm track width.
Rims are 14", front wheel is 8" width and rear is 10" width.

What I intend to do is to run the model in Flowizard comparing different diffuser + rear wing angles

Belatti, PM me for rates j/k
i just had to do this hahahaha

PS: No offence intended to flynfrog

np, all rates well sorted out