I'm getting a strange occurrence
Seems as though it cannot see the files even though they are where they should be and OF recognises the workingDir
Change the name.Alonso Fan wrote: ↑23 Jul 2017, 18:16I'm getting a strange occurrence
Seems as though it cannot see the files even though they are where they should be and OF recognises the workingDir
My rear wing end plates and supports look pretty much exactly the same.RicME85 wrote: ↑23 Jul 2017, 18:35This is what I will be entering. Have gone for the intro class. I created the floor, diffuser and wings with the CAESES online geometry generator. I changed the rear wing endplates and supports from what the tool generated and gone with something a bit more pleasing on the eye. At the front I have added dive planes as the simulation I did with the wings and floor setup I generated the balance was still a bit too rearward despite a decent size front wing/diffuser. I havent had chance to test the car with the dive planes nor the new RWEP and supports but I am hoping it will just nudge the balance forward slightly.
Not holding out much hope for race day but my intention is to just get a car entered and hopefully score some points that I can add too each race with some more testing.
http://i.imgur.com/22m8fXQ.png
Thanks for your help but I'm getting the same issue after renamingRicME85 wrote: ↑23 Jul 2017, 18:38Change the name.Alonso Fan wrote: ↑23 Jul 2017, 18:16I'm getting a strange occurrence
Seems as though it cannot see the files even though they are where they should be and OF recognises the workingDir
Front_wheel_DX
Front_wheel_SX
Rear_wheel_DX
Rear_wheel_SX
I can't wait to see the numbers of your car.
I got that error for a couple of times. Deleting the folders except the "input_files" folder on the case and starting fresh did solve that problem.Alonso Fan wrote: ↑23 Jul 2017, 18:16I'm getting a strange occurrence
http://i64.tinypic.com/kal7ns.jpg
Seems as though it cannot see the files even though they are where they should be and OF recognises the workingDir
So it goes 'input files' then just all the stls? Or am i still to keep folders like 'special bc' etc?Ft5fTL wrote: ↑23 Jul 2017, 21:55I got that error for a couple of times. Deleting the folders except the "input_files" folder on the case and starting fresh did solve that problem.Alonso Fan wrote: ↑23 Jul 2017, 18:16I'm getting a strange occurrence
http://i64.tinypic.com/kal7ns.jpg
Seems as though it cannot see the files even though they are where they should be and OF recognises the workingDir
Did you delete all the files other than the input folder and rebuild the case? Otherwise it won't make a difference if you made the change to the name.Alonso Fan wrote:Thanks for your help but I'm getting the same issue after renamingRicME85 wrote: ↑23 Jul 2017, 18:38Change the name.Alonso Fan wrote: ↑23 Jul 2017, 18:16I'm getting a strange occurrence
Seems as though it cannot see the files even though they are where they should be and OF recognises the workingDir
Front_wheel_DX
Front_wheel_SX
Rear_wheel_DX
Rear_wheel_SX
Edit: I've just tried running my 2016 le mans case and i get the same error. So it seems to be an error with my setup but not sure why