[MVRC] Mantium Virtual Racecar Challenge 2017

[CAEdevice]

I liked it when people were a bit more open with the CFD images... Although I understand why everyone wants to keep their designs secret...

I agree, the top teams are not very present on the forum.

This is my Monaco (and Nurburgring) car: what happens below the floor and into the sidepods is the same you can see in the "Intro car" (for both MVRC and CAESES models).

[Alonso Fan]

I liked it when people were a bit more open with the CFD images... Although I understand why everyone wants to keep their designs secret...

I agree, the top teams are not very present on the forum.

This is my Monaco (and Nurburgring) car: what happens below the floor and into the sidepods is the same you can see in the "Intro car" (for both MVRC and CAESES models).

https://www.dropbox.com/s/he59yp1y08s34 ... D.jpg?dl=1

How did you manage to open your cases in paraview?

[rjsa]

There's some extra post processing needed, I will dig it when I get to my computer.

[CAEdevice]

I liked it when people were a bit more open with the CFD images... Although I understand why everyone wants to keep their designs secret...

I agree, the top teams are not very present on the forum.

This is my Monaco (and Nurburgring) car: what happens below the floor and into the sidepods is the same you can see in the "Intro car" (for both MVRC and CAESES models).

https://www.dropbox.com/s/he59yp1y08s34 ... D.jpg?dl=1

How did you manage to open your cases in paraview?

I had problems with the "case.foam" file, but there are some VTK already done in "...\YourWorkingDir\postProcessing\sampleDict\2500"

[rjsa]

Even the flow lines?

[CAEdevice]

Even the flow lines?

No, I used "SurfaceLIC" filter (included in Paraview, but you have to load it from the plugins menu)

[Alonso Fan]

Even the flow lines?

No, I used "SurfaceLIC" filter (included in Paraview, but you have to load it from the plugins menu)

which vtk did you use?

[rjsa]

U near surface

[Alonso Fan]

U near surface

Thanks. How do I make a slice show surface lic?

[rjsa]

About opening the casein paraview: In the OF shell, being BlueCFD or VirtualBox run this:

>cd case_dir
>reconstructParMesh -constant
>reconstructPar -latestTime

Then open the case and set time to 1

Everything should work from there.

[CAEdevice]

About opening the casein paraview: In the OF shell, being BlueCFD or VirtualBox run this:

>cd case_dir
>reconstructParMesh -constant
>reconstructPar -latestTime

Then open the case and set time to 1

Everything should work from there.

Thanks I will try later

[rjsa]

I have a paraview state with a lot of flow streams set up, whoever wants it PM me an email address. It won't be a perfect match but is a close enough start point.

[rjsa]

U near surface

Thanks. How do I make a slice show surface lic?

Just open one of the speed vector slices, like U_zNormal_013.vtk and turn it on.

It does nothing on the scalar (pressure) slices.

[Ft5fTL]

This is the car that i used on the last race:

[CAEdevice]

Thank you very much for sharing!