Recharging in 0.5s should be difficult, when it would take an 800 kW source to charge a 400 kJ battery to full in that time.
Without losses, that is.
I wonder if they do go for a full charge/discharge. Wouldn't that put too much strain on the electrics, leading to over heating (kimi's fire)? Would operating below full capcity be more efficient??? They would have more batteries than needed, meaning more weight, but less kit for cooling?xpensive wrote:Recharging in 0.5s should be difficult, when it would take an 800 kW source to charge a 400 kJ battery to full in that time.
Without losses, that is.
richard_leeds wrote:I wonder if they do go for a full charge/discharge. Wouldn't that put too much strain on the electrics, leading to over heating (kimi's fire)? Would operating below full capcity be more efficient??? They would have more batteries than needed, meaning more weight, but less kit for cooling?
The other thing is that they only use KERS in bursts so they only need enough battery capacity for the largest single discharge as opposed to the full allowance for one lap. Let's say the hit the button twice a lap, then they only need 50% batteries which recharged between each burst.
I agree with you completely, but that's what Norbert Haug said in the RTL interview I translated for F1T..xpensive wrote:Recharging in 0.5s should be difficult, when it would take an 800 kW source to charge a 400 kJ battery to full in that time.
Without losses, that is.
According to formula1.com, "The regulations stipulate that the release must be completely under the driver’s control."Conceptual wrote:Can the ECU allow the KERS discharge button to operate on a pulse?
I was wondering if the driver had a knob that could set the pulse rate that the 60hp would kick in. Like, timing in music, so they could have 13/16 or 15/16 measures. It would equate to them "tapping" on the button very fast anyways, so could they simplify it with the ECU?
In what I said, the driver would have 100% control over the pulse, from 1/16 to 16/16, and the discharge button. It is no different than the driver tapping a rhythm on the button with his thumb.gridwalker wrote:According to formula1.com, "The regulations stipulate that the release must be completely under the driver’s control."Conceptual wrote:Can the ECU allow the KERS discharge button to operate on a pulse?
I was wondering if the driver had a knob that could set the pulse rate that the 60hp would kick in. Like, timing in music, so they could have 13/16 or 15/16 measures. It would equate to them "tapping" on the button very fast anyways, so could they simplify it with the ECU?
http://www.formula1.com/inside_f1/under ... /8763.html