I would like to rise two topics:
1. Regarding the Scrutineering report, one of the warning I had is
2.5
2.5 Only the parts specified in rule 2.1 and the text file in rule 2.4 should be included. No other guide or provided mandatory parts must be submitted. The combined size of the stl files (before compression) must be below 160MB for ASCII stl, or below 40MB for binary stl.
2.1 An entry should be a single compressed archive file (ZIP etc) named using the format “<team>_<round>_<version>”. It must contain a directory structure “input_files/geometry/“ which contains:
A directory named “special_bc”:
(rule 7) One engine inlet surface, with a filename starting with “engineIn”
A directory named “monitoring_surfaces”:
(rule 6) Each heat exchanger monitoring surface as a separate stl-file (front face of heat exchanger translated rearward along its normal by 30mm)
A directory named “porous_media”:
(rule 6) Each (left and right hand sides) heat exchanger volume as a separate stl file
A directory named “high_res_surfaces” (rule 9.2).
Directories “frt_suspension” and “rr_suspension” (rule 14).
A directory named “vehicle_body”: All remaining bodywork.
2.4 A plain text file must be included in the archive to specify the offset for the following parts compared to their position as supplied in the parts file, even if they have not been moved, stating the following:
Vehicle rake in deg
Vehicle ride height adjustment in mm
I double checked everything and do not know what to change, which according to the rules will lead to a penalty, which will be pity, taking in to account all the effort I've put in to this competition.
May I get the exact reason for not meeting the 2.5 rule?
2. I noticed that the exhaust flow is missing or it is relatively low comparing it to the results I had back in 2020 (my first and only attempt in MVRC)
This is how it looks in paraview:
And the triangles of the "MAND_Exhaust_Outlet_Surface":
Most probably this is affecting all the participants.
Regards,
Krasen
