Single Cylinder Crankshaft Oil Drilling

Post here information about your own engineering projects, including but not limited to building your own car or designing a virtual car through CAD.
coseng
0
Joined: 10 Dec 2019, 02:29
Location: Jersey City, NJ
Contact:

Re: Single Cylinder Crankshaft Oil Drilling

Post

>>180 deg in the upper main is more than enough for the rod bearing. It is not unusual to have a groove of less than 180 deg such

Thanks. A 170 degrees or so groove in the upper bearing half sounds like the way to go.
Chris
Cosentino Engineering
www.cosentinoengineering.com

coseng
0
Joined: 10 Dec 2019, 02:29
Location: Jersey City, NJ
Contact:

Re: Single Cylinder Crankshaft Oil Drilling

Post

Just to follow up, some more internet digging turned up clevite's catalog which backs up your 'less than 180 in the upper only' groove advice. It says a 140 degree groove in the upper is about optimum.

https://www.mahle-aftermarket.com/media ... -40-16.pdf

Chris
Chris
Cosentino Engineering
www.cosentinoengineering.com

63l8qrrfy6
368
Joined: 17 Feb 2016, 21:36

Re: Single Cylinder Crankshaft Oil Drilling

Post

Well I did use to work for Mahle!

coseng
0
Joined: 10 Dec 2019, 02:29
Location: Jersey City, NJ
Contact:

Re: Single Cylinder Crankshaft Oil Drilling

Post

>>Well I did use to work for Mahle!

Not your average forum troller!
Chris
Cosentino Engineering
www.cosentinoengineering.com

User avatar
coaster
16
Joined: 30 Jun 2012, 05:10

Re: Single Cylinder Crankshaft Oil Drilling

Post

You can use the oil drilling to core out the main journal thus reducing mass, better for rpm, maybe buy an old f1 conrod TJ if it suits the stroke youre aiming to use.

coseng
0
Joined: 10 Dec 2019, 02:29
Location: Jersey City, NJ
Contact:

Re: Single Cylinder Crankshaft Oil Drilling

Post

Both ends of the crank will have a large retaining bolt so will be drilled as much as allowable.

For the conrod, Carrillo's custom rods are not too pricey so not worth trying to adapt a part from something else.
Chris
Cosentino Engineering
www.cosentinoengineering.com