TheRacingElf wrote: ↑Thu Oct 31, 2019 6:07 pm
Anything about DRS?
3.10 Rear Wing
3.10.1 Rear Wing Profiles
Bodywork declared as “Rear Wing Profiles” must:
a. Lie within RV-RW-PROFILES.
b. In any Y plane:
i. Contain exactly two sections, except outboard of Y=550 where a single section will be allowed.
ii. The rearmost section, which will be known as the “RW Flap”, must have a chord smaller than the chord of the adjacent section where one is present.
iii. The section(s) may not contain any concave radius of curvature smaller than 100mm
iv. Where there are two sections, the distance between the two sections must lie between 10mm and 15mm at their closest position, except, in accordance with Article 3.10.10, when this distance must lie between 10mm and 85mm when the DRS system is deployed.